Model F50 disc-actuated mechanical flow switch

Downloads

Model F50 disc-actuated mechanical flow switch

Magnetrol® flow switches are highly reliable flow control solutions utilized to sense the presence or absence of flow in horizontal pipelines. Disc-actuated Model F50 switches are in-line type used for sensing clean liquids in 2 inch or smaller line sizes.

Mechanical flow switches

Technology

F10: Force of liquid or gas flow against a vertical flow vane mounted in a line causes the vane to pivot to a horizontal position, moving an attraction sleeve into the field of a switch magnet. This pulls the magnet toward the sleeve and actuates the switch.

F50: The force of liquid flow through a valve body and against a flow disc causes it to lift out of the flow path. The attraction sleeve at the top of the disc assembly moves into the field of a switch magnet, attracting the magnet and actuating the switch.

No calibration required
Bronze or stainless steel construction
Process pressures to 1150 psig (79 bar)
Process temperatures to +750°F (+400°C)
Actuation on increasing or decreasing flow
In-line mounting
Bodies for flow lines from ¾” to 2”

Options

Dry contact or hermetically sealed switches
Actuation flow rates from 0.8 to 24.8 gpm

Common applications

Flow: Air flow
Flow: Centrifugal pump protection
Flow: Compressors & Pumps
Flow: Gas mixtures flow
Flow: Liquified gases
Flow: Single gas flow

Petroleum refining

Refinery flow applications

Renewable energy

Biogas
Hydroelectric
Solar

Water & wastewater

Blower air flow
Digester gas flow

The rate of flow through the valve body raises or lowers the disc. This in turn raises or lowers the magnetic sleeve, within its sealed non-magnetic barrier tube. On an increasing flow rate, the magnetic sleeve rises into the field of the permanent magnet, located outside the barrier tube, actuating the attached switch mechanism. When the flow rate drops, below the rate for which the flow disc is calibrated, a reversal of this action occurs.